9006 EXTENSION WIRE 48 INCH | 1 EACH

Need to install a resistor but don't want to splice into your factory wiring? These harnesses make adding load to your headlight or fog light system easy and clean.

An easy way to add the dim feature (90LM output) when your headlights are on.

An easy way to add the dim feature (90LM output) when your headlights are on. Simply plugs in between your low beam headlight connections. The single pin connector then plugs into the dim wire of the V6 Triton bulb.

Need to install a resistor but don't want to splice into your factory wiring? These harnesses make adding load to your headlight or fog light system easy and clean.

An easy way to add the dim feature (90LM output) when your headlights are on. Simply plugs in between your low beam headlight connections. The single pin connector then plugs into the dim wire of the V6 Triton bulb.

For use when adding our splitters and resistors or installing D2S Micro headlights to a sealed headlight assembly.

An easy way to add the dim feature (90LM output) when your headlights are on. Simply plugs in between your low beam headlight connections. The single pin connector then plugs into the dim wire of the V6 Triton bulb.

Plug-N-Play: Forget about crimp-on wire taps, these convenient "Y" pigtails make splitting or doubling the signals from your headlight or fog light system easy and clean.

Need to install a resistor but don't want to splice into your factory wiring? These harnesses make adding load to your headlight or fog light system easy and clean.

2 pin 12" wire extension for VLR load resistors.

An easy way to add the dim feature (90LM output) when your headlights are on. Simply plugs in between your low beam headlight connections. The single pin connector then plugs into the dim wire of the V6 Triton bulb.

An easy way to add the dim feature (90LM output) when your headlights are on. Simply plugs in between your low beam headlight connections. The single pin connector then plugs into the dim wire of the V6 Triton bulb.

The DuoTap harness is highly recommended for an quick and easy no cutting connection! They literally take just minutes to install!

7.5" BLACK CABLE TIE NYLON #10 SCREW MOUNT | 10 PACK

Wiring adapters to convert last generation 2.5 V3 Triton VLR resistors to use with the V6 Triton system

8" BLACK CABLE TIE NYLON | 10 PACK

Easily splice wires without stripping insulation with our DUO-TAP connectors.

Easily splice wires without stripping insulation with our SOLO-TAP connectors.

High temp mounting tape for VLR 6OHM and 3OHM HD resistors

Easily make 2 pin connectors without stripping insulation with our DIY connectors.

Silicone dielectric compound.

1/4" BLACK VINYL TUBING | 1 FOOT

1/4" BLACK EXPANDABLE BRAIDED SLEEVING | 1 FOOT

3M SCOTCHLOK MOISTURE-RESISTANT GEL FILLED CONNECTORS 804 WIRE SPLICE VAMPIRE TAPS