WIRE HARNESSES: HD RELAY GUIDE

 
Cutting Involved
Cutting involved:
Little/None
1 hrs Install Time
Time to install:
1 hours (estimate)
Tools Required
Tools Required:
— Sandpaper
— Common Hand Tools
Materials Required
Materials Required:
— Morimoto Relay Harness
 
Warning: By reading this document, I agree that it is only intended to be used as an educational guide. VLEDS makes no guarantee on any finished results, nor are they to be held responsible for any damage, misuse, or personal injuries. Use at your own risk. If you are unable to clearly understand and adapt the information below to your own application, professional installation is available and recommended.

1. INSTALL DIAGRAM

Diagram will also be included on harness packaging.

SX1

2. HARNESS INPUT

If your harness is not the 9006 or H10 size, an input adapter is included to convert the harness input to a different size.

SX1

3. POWER LEAD

The 12V+ Power lead of the harness needs to go directly to the positive terminal of your car's battery. NOTE: If you have a battery not easily accessible from the front (mounted in trunk or on firewall), you should have a 12V+ jumper terminal in the engine bay you can run this connection to.

SX1

4. TROUBLESHOOTING

The input and outputs of the harness can be plugged in either way. If you aren't seeing proper function of the harness, you may need to flip the connector over.

Aim1

4. TROUBLESHOOTING

Ensure you have the grounds to bare metal, the power lead directly to a 12V+ power source.

SX2
 
CONTACT US