WIRE HARNESSES: STANDALONE CAN-BUS GUIDE

— Can-bus: Morimoto Standalone
 
Cutting Involved
  • Cutting involved:
  • Little/None
1 hrs Install Time
  • Time to install:
  • 1 hours (estimate)
Materials Required
  • Materials Required:
  • — Morimoto Standalone Canbus Harnesses
 
Warning: By reading this document, I agree that it is only intended to be used as an educational guide. VLEDS makes no guarantee on any finished results, nor are they to be held responsible for any damage, misuse, or personal injuries. Use at your own risk. If you are unable to clearly understand and adapt the information below to your own application, professional installation is available and recommended.

DIAGRAM FOR USE

The low-beam canbus harnesses have a single input and a single output. The Bi-Xenon versions of the harnesses have two outputs: one for the ballast and one for the high beam.

Aim1

TROUBLESHOOTING

The low beam canbus harnesses can be plugged in ultimately either way. If you aren't seeing proper function of the harness or any activity at all through it, you may need to flip the connector over depending on the polarity of your stock wiring.

Aim1
CONTACT US