WIRE HARNESSES: H4 DUAL CYCLE HARNESS GUIDE

— H4: Dual Output Motocycle
 
Cutting Involved
Cutting involved:
Little/None
1 hrs Install Time
Time to install:
1 hours (estimate)
 
 
Warning: By reading this document, I agree that it is only intended to be used as an educational guide. VLEDS makes no guarantee on any finished results, nor are they to be held responsible for any damage, misuse, or personal injuries. Use at your own risk. If you are unable to clearly understand and adapt the information below to your own application, professional installation is available and recommended.

DIAGRAM FOR USE

The diagram at right is how the dual-output H4 Cycle harness should be installed.

Quad1

2. POWER LEAD

The 12V+ Power lead of the harness needs to go directly to the positive terminal of your bike's battery.

SX1

3. GROUNDS

Ensure you have the grounds to bare metal and not a plastic surface.

SX2
 

4. HELPFUL TIPS

The outputs of the harness can be plugged in either way. If you aren't seeing proper function of the harness, you may need to flip the connector over.

Aim1
CONTACT US